| Determination of Eleutheroside by HPLC
a. Acetronitrile(HPLC) b.Acetic acid (A.R) c. Nanopure water d.Methanol(A.R)
HPLC (Shimadzu) Analytical balance (1/10000) Ultrasonic cleaner
0.45μm PTFE filter 50ml volumetric flask Screw cap vials
3) HPLC condition
Column: Kromasil C18 5m 4.6×200mm
Detector: UV 270nm
Mobile Phase: A=2% Acetic acid B=Acetronitrile
Flow Rate: 1.0 ml/min
Time(min) %A %B
0.01 90 10
15 65 35
18 65 35
20 90 10
Accurately weigh 200mg extraction into 50ml volumetric flask. Add Methanol to volume and sonicate to mix, filter through a 0.45μm PTFE filter into a screw cap vial and proceed with the analysis.
Standard preparation /calibration
Prepare a standard solution (approximately 0.2mg/ml in Methanol) using a standard of Eleutheroside，Sonicate for about 10 minutes and transfer to screw-cap vials and can be stored in the refrigeration.
Determine the peak areas of the Eleutheroside on the sample chromatogram and compare to the corresponding peaks in the chromatogram for the standard solution. Calculate the weight percent.